Two disposable vapes on the same shelf, both claiming 20,000 puffs, one at €9 and one at €19. The difference is not branding, and it is not only the size of the liquid reservoir. It sits in five components, and four of them decide how the device behaves in its last third rather than its first.
Where the money goes
The cell
Battery capacity is the single largest cost item after the liquid itself, and it is the specification manufacturers quote least often. A larger cell does not increase the puff count directly; it determines how long the device can hold its output before the voltage sag makes each draw weaker. Two devices with the same claimed count behave very differently at 20% charge, and that difference is the cell.
The number to look for is mAh. Our explanation of battery capacity covers what the figure does and does not tell you, and why a device weakens at low battery describes the symptom that separates a good cell from a cheap one.
The coil
Mesh coils cost more than wound wire and heat more evenly, which matters most at the end of a device's life: an uneven coil develops a hot spot and scorches the wick before the liquid is gone. On a cheap device this shows up as a burnt taste with a quarter of the reservoir still full. The mesh coil explainer covers the construction difference.
Sealing and airflow
Precision in the housing is invisible until it fails. Cheaper mouldings have wider tolerances at the mouthpiece and the base, which is where leaks start, and most budget devices have fixed airflow rather than an adjustable ring. Fixed airflow is not a defect by itself, but it means the draw is whatever the factory chose, which is usually loose enough to suit everyone and ideal for nobody.
The chip, if there is one
A display, a puff counter and a low-liquid warning all require a microcontroller. They add cost and they add failure modes. Whether they are worth it depends on whether you use the information: a percentage readout that drifts is worse than no readout, as the puff counter guide explains.
Compliance and packaging
Notification through EU-CEG, batch traceability, child-resistant packaging and translated labelling all cost money per SKU, and they cost the same whether the device retails at €9 or €19. On a cheap device they are a larger share of the price, which is one reason very cheap stock often originates outside the EU notification system.
What the extra money does not buy
It does not buy a proportionally longer life. Puff counts scale roughly with liquid volume, and liquid is cheap relative to hardware. Doubling the price does not double the puffs; it buys consistency across the puffs you already had.
It also does not buy a better flavour. Flavour is a formulation decision, and a well-made budget device with a simple profile can taste cleaner than an expensive one with a complicated blend that has been sitting in a warehouse for a year. Our guide to why flavour fades covers the storage side.
The numbers that actually compare devices
| Metric | What it tells you | Where it misleads |
|---|---|---|
| Claimed puffs | Rough liquid volume | Measured at one second per draw |
| mAh | How stable output stays | Says nothing about coil efficiency |
| Liquid volume | Real ceiling on life | Rarely stated for sealed devices |
| Price per puff | Value across sizes | Ignores how much you waste at the end |
| Coil type | Consistency at low liquid | Mesh quality varies enormously |
Price per puff is the honest starting point, and the cost per puff method shows how to calculate it across a range of sizes. But it is a starting point: a device that turns harsh at 70% of its claimed count has an effective price per puff 40% higher than the label implies.
Where the curve flattens
In the current EU market the useful step is between the cheapest tier and the middle one. That step buys a cell that holds voltage, a coil that does not scorch early, and a housing that does not leak in a bag. Above the middle tier, the increments are display, adjustable airflow, dual chambers and brand. Those are real features, but they are preferences rather than reliability.
A practical rule: if you vape a device to the end, pay for the cell and the coil. If you replace devices before they are empty because the flavour has gone flat, pay for the smaller format instead and accept more frequent changes. The device lifetime guide covers what actually shortens life.
How to judge a device you have not tried
Three signals from the specification sheet separate a considered design from a repackaged one. First, whether the manufacturer states the cell capacity at all; silence usually means a small cell. Second, whether the coil type is named. Third, whether the airflow is adjustable, since an adjustable ring is only worth fitting if the housing is precise enough to make it meaningful.
The rest of the decision sits outside the device itself: seller, payment route and delivery rules matter more than the last euro of hardware. The nine-point buying checklist covers those before you compare specifications.
Two signals from the packaging matter as much: a batch code that can be traced, and a nicotine declaration in mg/ml rather than a percentage alone. Our label guide covers the required elements.
Is a more expensive device cheaper in the end?
Sometimes, and only by a margin. If a €19 device delivers 90% of its claimed puffs at consistent output and a €9 device delivers 65% before turning harsh, the effective cost per usable puff is close. The expensive device wins on experience rather than on arithmetic, and it wins clearly only when you would otherwise have discarded the cheap one early.
That is why the comparison worth making is not price against price but usable puffs against usable puffs, which requires knowing your own habit. Someone who takes four-second draws will get through any device faster than the label implies, and the gap between a good cell and a poor one widens accordingly.
Frequently asked questions
Do expensive devices use better liquid?
Not necessarily. Liquid cost is a small part of the bill of materials, and formulation quality varies within every price tier. What correlates with price is consistency of supply, which affects how fresh the stock is when it reaches you.
Why do two devices with the same puff count feel so different?
Because the count is a liquid-volume estimate, while the feel is cell voltage, coil temperature and airflow. The first is marketing, the last three are engineering.
Is a bigger device always better value?
Only if you finish it. A large device that sits half-used because the flavour has tired is worse value than two small ones you finish. The big puff format guide covers the trade-off in size terms.
Does a display justify the price difference?
If you ration the last of a device, yes. If you use a device until it stops, the display changes nothing except the number of things that can break.
Should I buy the cheapest device for a first try?
Buy a mid-tier device in a simple flavour. A first purchase is about learning your preferred strength and draw, and a device that behaves inconsistently makes that harder to work out.